In this video I'm going to quickly show you how to calibrate flow rate for your 3d printer using Cura.

I'll explain what flow rate controls and why we might need to calibrate it. I'll also show you how to run a simple test print that you can measure to see if your flow rate needs adjusting.

How to calibrate e-steps: https://youtu.be/qOj8L0IXcfA

..............................................................................................................................................................

BUY ME A COFFEE
If you're enjoying my content, why not consider supporting the channel by buying me a coffee?
Even very small amounts are greatly appreciated and re-invested into bringing you better content.

https://www.buymeacoffee.com/rickyimpey

You can also use the YouTube 'Thanks' button above if you prefer.
...............................................................................................................................................................

Affiliate links (If you purchase something after clicking any of the below links I may earn a small commission at no cost to you. This is a great way to support the channel)

Vernier Calipers
US https://amzn.to/3MZ1ohI
UK https://amzn.to/3b6hjxG