Welcome to Robinson Foundry. In this video I will be using 3d printed patterns to cast a bronze knife/dagger. I modeled the dagger in fusion 360 and then printed the patterns on my Creality CR10 and Elegoo Saturn 3d printers. I then made a sand mold using petrobond sand. I melted bronze in my homemade furnace until it reached a temperature of about 2200 degrees Fahrenheit or 1200 degrees Celsius and then poured it into the mold. I finished the dagger by wrapping the handle in copper wire. I did not come up with the design for this dagger. I was impressed by an image I found online and tried to recreate it.

The dagger's overall length is 11”/280mm and it weighs 9oz/256 grams.

▬ More Videos ▬▬▬▬▬▬▬▬▬▬▬▬

Bronze Megalodon Tooth https://youtu.be/BDb7vrZfJOI​​

Bronze Khopesh Sword https://youtu.be/IyufkYiP0WM​​​

Bronze Statue https://youtu.be/ALYUiTsDJZg​​​​

Bronze Dagger https://youtu.be/aOHdMIK8cA8​​​​

Sterling Silver Megalodon Teeth https://youtu.be/g_IC0FVDcvE​​​

▬ Music used ▬▬▬▬▬▬▬▬▬▬▬▬

Music: https://www.davidcuttermusic.com​ / @dcuttermusic