This is a must have DIY mod for your sim racing pedals and simulator rig. Add simulator Rumble Feedback to the Logitech pedals or any other pedal set.

Add to the immersive experience with this mod ! Highly recommended!

You can adjust and mix feedback for :
- Left and Right Vibration
- Wheel slide
- Speed
- RPM
- Acceleration slide
- Wheel Lock
- Gear Change
- Idle vibration

Items used:
Arduino UNO BG https://bit.ly/3JpJmFj
Motor shield V2 https://ebay.to/2DTtEmd
USB Cable
Rumble motors eBay https://ebay.us/jfCzvO
25mm clamps eBay https://ebay.us/hust2D
Nuts and bolts https://ebay.to/2O2KRuO
Plastic Box https://ebay.to/2E7LPFD
12V power supply https://ebay.us/OpXvXv
Soldering Iron https://ebay.us/VIwU6k
Butane Tourch https://ebay.us/KhS3oB
DC plug https://bit.ly/3oLILUT
This site contains affiliate links for which I may be compensated

My settings
I have mixed in some left and right vibration into the pedals.
Wheel lock for the brake pedal, acceleration and wheel slide in the throttle pedal.

Expandable to 12 Motors
Each motor shield can support 4 motors and these are stackable.

The video shows how to add 2 motors to give the basics.

Additional force feed back motors can be added on your rig or seat.

Supported Games
Assetto Corsa
Project Cars
Codemasters games
Dirt Rally
Iracing
Automobilista/ RF1
RF2
Raceroom
ETS2 ATS
SIMBIN
LFS/RBR

Tested and gameplay in Assetto Corsa

Note: The 12V power supply is adjusted in the sketch to output 5V. It is possible to run more voltage through your motors but this may shorten their life. I have shown the "safe" base setting.

It is recommended to wire power directly to the motor shield as shown in the video.

Thank you for watching, all questions and feedback are welcome.

If you know someone who might be interested in this project please share the video with them.

SIMHUB | Credit to Author: Wotever |

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.
https://creativecommons.org/licenses/by-nc-nd/4.0/