Home Assistant hassbian mqtt switches using esp8266 node mcu and arduino ide for configuration and automations file content
follow links below
******************************
i forgot to mention that in addition to Reset and Flash mode buttons which are only useful when you are setting up the esp i also connected the GPIO 16 to the RST (reset) pin which is necessary to WAKE UP the ESP from Deep Sleep and Reset
for OTA updates
***********************************
After making it, using the bare esp module ,i realized that it's much easier and a better option to just use a wemos d1 mini or a node mcu dev board ,which i'll do when i'll make other switches like this
but i had this one bare module suffering from existential crisis so, i had to use it somewhere and it helped me a lot in learning what not to do again :D

##############################################
For Sketch/Code
PLEASE LIKE , SUBSCRIBE and COMMENT
Send me a Mail ,My Email Address is in the About Section of this Channel